TEX1002LCD
19
/ 26
User Manual
Rev. 1.0 - 22/08/14
5.4.4 Setup Menu (Set)
This menu lets you view and set operating frequency.
Menu 7
F1
Operating frequency setup. Set a new frequency value and then
press the
ENTER
button to confirm your selection; the transmitter
unlocks from current frequency (the
LOCK
LED turns off) and will
lock to the new operating frequency (
LOCK
turns back on again).
If you press
ESC
or let the preset time time out, the previous frequency
setting is retained.
5.4.5 Miscellaneous Menu (Mix)
This menu lets you set equipment address in an I
2
C bus serial connection:
Menu 8
IIC
I
2
C address setting. The I
2
C network address becomes significant when
the transmitter is connected in an RVR transmission system that uses
this protocol. Do not change it unless strictly required.
5.4.6 Version Menu (Vrs)
This screen holds equipment version/release information::
Menu 9
Note that these are readings, rather than settings, and cannot be edited (note the
empty arrow).
Rel
Firmware release information.
Dat
Release date.
Tab
Shows table loaded in the memory.
