QWICK KURB
®
, INC.
Long Term Installation Manual
To secure the markers/bollards:
4. Position the Stabilizing Bars so that their holes are above the pre-molded holes in the top
of the L60 SEPARATOR (Fig 9). If necessary, use the rubber hammer to align the
Stabilizing Bars with the pre molded holes.
Fig 9
5. Place a black Securing Arc on the L60 SEPARATOR, snugly against one side of the
marker/bollard’s reboundable Flex Boot, aligning the hole with the hole in the
Stabilizing Bar and the hole in the L60 SEPARATOR.
6. Place the long screw through the single top hole of the S65 black Securing Arc, and
tighten securely.
IMPORTANT: The 4” hex screw must be installed first. For all screws, use 7/16” Six Point Socket to
avoid stripping the hex heads. If using an electric drill, DO NOT EXCEED 800 RPM!
7. Place two short screws into the two side holes of the S65 black Securing Arc, and
tighten securely.
8. Repeat the process with a second black Securing Arc on the other side of the
reboundable Flex Boot (Fig 10). Continue the process of installing two S65 black
Securing Arcs for each marker/bollard’s reboundable Flex Boot.
4” SCREW - FIRST
The Black
Securing Arc
Requires All 3
Screws! The
top Long Screw
ALWAYS is
installed FIRST!
2-1/2" SCREWS - SECOND
Fig 10
Phone: 800-324-8734
Fax: 813-645-4856
www.qwickkurb.com
1/21/2016
24
