QWICK KURB
®
, INC.
Long Term Installation Manual
TOOLS AND EQUIPMENT CHECKLIST
For a typical installation, we recommend the items listed below.
NOTE: Always follow manufacturers’ instructions when using any power, impact or other tools and
equipment.
Item
Description
5 Horsepower Generator
5,000 watts.
Variable Speed Rotary Hammer
300-700 no load rpm and 1,650-3900 rpm; 1” bit capacity, e.g., Bosch Terminator
Model 11222EVSG or Milwaukee Hawk Model 5362-1. Drills holes into asphalt or
concrete for anchors.
Carbide Tipped Bits for Rotary
Hammer
ANSI diameter 3/4”; minimum usable length 10”. The quantity needed depends on the
length and number of installations and the density of the underlying material.
Electric Impact Wrench
1/2”; maximum torque 330 ft. lbs., e.g., Ingersoll-Rand Model IR8053 or DeWalt Model
DW290 – (connects the L60 SEPARATOR with connecting bolt & nut).
15/16” Shallow Socket
Use with electric impact wrench to tighten FS50 anchor sets
17mm Shallow Socket
Use with electric impact wrench (for L60 SEPARATOR connecting bolt & nut).
Electric Drill
1/2”; 0 to 550 rpm, variable speed e.g., Makita Model 6402 and a 7/16” Six Point
Socket - installs hex screws for S65 black Securing Arcs (use the low setting torque
to avoid striping hex heads.)
Extension Cord
50 foot heavy duty grade 12 gauge.
Rubber Hammer
Assists in tapping the markers/bollards and L65 Reflective Arcs into place.
Hammer
Taps anchors into the drilled holes.
Soapy Water
Assists in sliding the markers/bollards into place.
Stiff Broom
Clears debris from the intended placement location for the L60 SEPARATOR.
For lengthy installations in excess of 1,000 feet, you may wish to rent our optional
Conveyor.
To install a large number of markers/bollards you may wish to purchase our Q640 Panel
Puller. Refer to
Appendix A
on page 31 for more information.
Phone: 800-324-8734
Fax: 813-645-4856
www.qwickkurb.com
1/21/2016
8
