QWICK KURB
®
, INC.
Long Term Installation Manual
APPENDIX A - Q640 PANEL PULLER
QWICK INSTALLATION
The reboundable Flex Boot of the marker/bollard has a short edge and a tall edge. The short
edge of the reboundable Flex Boot of the vertical marker/bollard fits into the center slot of
the one-meter L60 SEPARATOR. Notice that there is a small wedge in the slot (Fig 1). It is
easier to draw the reboundable Flex Boot from the opposite side of where this wedge is
located, but drawing from either side is effective. Your Panel Puller will grip the horizontal
band on the short edge.
SHORT SIDE OF THE FLEX
BOOT
WEDGE IN THE
SLOT
Fig 1
To use the Q640 Panel Puller:
TIP: Dip the reboundable Flex Boot into soapy water to start. (See page 21)
1. Position the reboundable Flex Boot into the L60 SEPARATOR slot with the short
edge facing toward the L60 SEPARATOR. Align the reboundable Flex Boot into the
slot, and start it with a gentle kick or hammer tap so that the marker/bollard stands
on its own.
2. Tilt the Panel Puller toward the reboundable Flex Boot and use the steel hook to grab
the horizontal edge of the boot (Fig 2). If the metal flanges of the Stabilizing Bar
scrape the top of the L60 SEPARATOR, you may have to tap them with a hammer
while pulling. Position the holes of the metal flanges to align with the small holes in
the top of the L60 SEPARATOR.
Phone: 800-324-8734
Fax: 813-645-4856
www.qwickkurb.com
1/21/2016
31
