Quickie R-net, Инструкция по эксплуатации

Страница: 96 / 108

2 3 .3 Pairing With a Bluetooth Device
The CJSM2-BT must first be put into Discovery Mode via the
sequence below:
• Enter Bluetooth Mode and select the device you wish to pair
with.
• Deflect the joystick in the forward direction and hold until
there is a beep. This will take approximately 10 seconds,
then release.
• Deflect the joystick in the reverse direction and hold until
there is a beep. This will take approximately 10 seconds,
then release.
• A screen will appear (Fig 2 3 .2).
• The flashing blue icon indicates that the CJSM2-BT is in
Discovery Mode.
Depending on which type of device is being paired with – a
Windows PC, an Android device or an iDevice – refer to one of
the following three sections:
21.4 Pairing With Windows
If the PC does not have integrated Bluetooth, then a receiver
dongle must be used and its drivers installed.
The following Bluetooth dongles are recommended:
• Trust BT-2400
• Linksys USBBT100-UK
• Belkin F8T012uk1 Version 1000
Once a Bluetooth connection is confirmed, the following
process should be undertaken on the PC:
• Enter My Bluetooth Devices (Fig 2 3 .3).
• Click ‘Add’ to open the Bluetooth Device Wizard (Fig 2 3 .4).
• Check the box marked ‘My device is set up and ready to be
found’ (Fig 2 3 .4).
• Click ‘Next’ (Fig 2 3 .4).
• The PC will now search for local Bluetooth devices.
• The available Bluetooth devices are shown on the screen
(Fig 2 3 .5).
• Click on the New Device name e.g. 'Tom's PC' and then
click on ‘Next’ (Fig 2 3 .5).
Fig.2 3 .2
Fig.2 3 .3
Fig.2 3 .4
Fig.2 3 .5
249044 Rev. A 96 R-Net Control System w/Omni2