Quickie R-net, Инструкция по эксплуатации

Страница: 65 / 108

Switch Control Setup
Certain Omni2 commands can be assigned to iDevice
commands. The Omni2 commands are detailed below.
Time related deflections (nudges) of the joystick in each
of the four directions , Page 61 .
Fig. 18.1 6
Fig. 18.1 7
Fig. 18.1 8
Fig. 18.1 9
• Forward Short
• Reverse Short
• Left Short
• Right Short
• Forward Medium
• Reverse Medium
• Left Medium
• Right Medium
• Forward Long
• Reverse Long
• Left Long
• Right Long
The timings associated with the nudges are programable.
Refer to the Bluetooth Programing chapter for more
information.
Set the R-Net programable parameter Mode to Switch
Control. Refer to the Bluetooth Programing chapter for more
information.
Note:
Within Accessibility there are Auto Scanning and Auto Hide
options. It is recommended that these options are turned off
for the initial set up.
To enable Switch Control on the iDevice and assign
commands:
• From the iDevice Settings menu, select General >
Accessibility (Fig 18.1 6 ).
• Set Switch Control to ON (Fig 18.1 7 ).
• Select Switches (Fig 18.1 8 ).
• Select External (Fig 18.1 9 ).
• Select Add New Switch ( Fig 18. 20 ).
• This screen is displayed (Fig 18.2 1 ).
• Activate the Omni2 command you wish to assign to the
iDevice; for example, a long reverse nudge.
• When the command has been received, this screen is
displayed (Fig 18.2 2 ).
• Enter a convenient name – for example, long reverse – and
then Save (Fig 18.2 3 ).
• This screen is displayed (Fig 18.2 4 ) .
• Select the iDevice command you wish to assign; for
example, Move To Next Item (Fig 18.23 4 ).
• This screen wil l appear and the process can be repeated to
assign further commands (Fig 18.2 5 ).
249044 Rev. A 65 R-Net Control System w/Omni2