QuercusVL Programming Manual
Note that:
●
when positions are indicated in the lane (in metres), 0,0 position refers to the image
bottom.
●
when positions are indicated in the image (in pixels), 0,0 position refers to the image
top.
The "virtual lane" parameters will be written in a configuration file. There is an example
available in the installation folder: “
Simulation/Simulation Type/Data/Simulation.ini”
This file will contain several lines, divided into:
●
Comments: all lines starting with “#” character are considered as comments and
ignored by the simulator.
●
Unit events: all lines will represent vehicle movements.
Several vehicles can be simulated. These are managed by a single identifier (integer value).
There are three types of vehicles available, each of them in two different models: car, van and
truck.
Each instruction refers to a position of a vehicle at a given time. Using two consecutive
positions of a vehicle, the simulator understands the movement. For example, if it indicates
that the vehicle 'v1' is at position 0 and after 3000 milliseconds is set to 2000, the simulator
assumes that between these instructions (3000 milliseconds) the vehicle has been moving at
Quercus Technologies
200
6
4
0
p
ix
el
s
2
5
m
4.5 m
480 pixels