LTE-A Module Series
EM160R-GL_Hardware_Design 5 / 73
Updated the description about EVB (Chapter 2.4).
Added the ripple and VBAT data in the figure of power supply limits (Figure 3).
Updated the turn-on and turn-off timing information (Chapters 3.4.1.1 and 3.4.2.1).
Deleted the information about turning off the module through AT command.
Updated the module reset information (Chapter 3.5).
Changed pin 24 into VDDIO in the table of PCM interface pin (Table 13).
Deleted the figure of PCIe turn-on timing requirements of M.2 Specification.
Updated the figure of thermal dissipation area on bottom side of the module (Figure 33).
1.3.0
2023-06-05
Deleted the related information of EM120R-GL.
To meet the specific demanding of Lenovo.
Iyukee SHEN/
Lewis PENG
Updated the PCIE_REFCLK in turn-on timing (Figure 7).
To prevent module unrecognition problems caused by incorrect reference clock timing.
Iyukee SHEN
Updated the PCIE_REFCLK and CLKREQ# in timing of resetting the module (Figure 11).
To prevent module unrecognition problems caused by incorrect reference clock timing.
Iyukee SHEN
Updated the PCIe Interface Reference Circuit (EP Mode) (Figure 16).
To prevent module unrecognition problems caused by incorrect GPIO configuration
during host turn-on.
Iyukee SHEN
Updated the PCIe D3 Cold State Timing (Figure 17).
The timing of the wake-up control signal is provided to the customer, which more
intuitively shows the process of the module from D3cold to D0 state.
Iyukee SHEN
Updated reference circuit of DPR (Chapter 3.9.5).
To prevent customers from directly connecting, which may cause the module to fail to
work properly.
Iyukee SHEN
Updated configuration of config pins (Figure 24 and Table 24).
To meet the specific demanding of Lenovo.
Iyukee SHEN
Added B29/B32/B46 in Rx Sensitivity (Chapter 4.1.2).
To add the data of Rx only.
Lewis PENG
Remove the type Compass in GNSS frequency (Chapter 4.2).
To follow the specification of EM160R-GL.
Lewis PENG
Updated the data in GNSS performance (Table 35).
To add the data of GNSS performance.
Lewis PENG
Updated the top view of the module (Chapter 6.2).
Follow Quectel standard.
Iyukee SHEN
Added the description of module installation (Chapter 6.4).
To remind customers to assemble correctly so as to make sure the normal operation of
the module.
Iyukee SHEN
Updated packaging specifications (Chapter 6.5).
Follow Quectel standard.
Iyukee SHEN
1.3.1
2023-07-15
Added a note to the host in the procedure of turning on (Chapter 3.4.1).
To remind customers not to drive RESET# low after FULL_CARD_POWER_OFF# is
de-asserted at booting stage so as to turn on successfully.
Fung ZHU
Updated the pulling down time of RESET# (Chapter 3.5).
To meet the specific demanding of Lenovo.
Fung ZHU
Updated the time of T1 in the turn-off procedure (Table 9).
To disable PCIe interface successfully by asserting PERST#.
Fung ZHU
1.3.2
2023-09-01
Updated the timing of RESET# (Table 11).
To meet the specific demanding of Lenovo.
Fung ZHU
