QubicaAMF 400288005, Руководство по установке

Страница: 27 / 147

BES X installation manual BES X system configurations
P/N: 400288005; Rev: L, 09/21 17
3.2 EasyKey console – brief description
The EasyKey is the keyboard console. It gives access to the basic on-lane functions of the BES X system.
The EasyKey console is Intercom-ready. This does not mean that the Intercom system will be automatically
available on the lanes because the Intercom system must be purchased separately.
During the operation of the lanes, only the active buttons are lit up on the EasyKey console.
During the boot-up of the system, the EasyKey console will light up different buttons (letters and numbers),
then a single character will blink for a few seconds:
•
“O” button blinking: The EasyKey console is configured to run in the “Twin” configuration with two
EasyKey consoles on the same pedestal;
•
“Q” button blinking: The EasyKey console is configured to operate as a single console with a single
pedestal (one EasyKey console per lane with a single pedestal or one EasyKey console per pair of
lanes).
There are two generations for the EasyKey consoles. The new EasyKey consoles have the following part
numbers:
•
EasyKey Rev.2, International P/N: 288150032;
•
EasyKey Rev.2, Russian P/N: 288150033;
•
EasyKey Rev.2, Japanese P/N: 288150034.
The EasyKey Rev.2 consoles are supported from:
•
Conqueror Pro 11: version 11.43.04 or higher;
•
Conqueror Pro 12: version 12.21.01 or higher.
3.2.1 EasyKey Pair console
In this configuration, the following devices are installed on each pair of lanes:
•
the camera (Q-Vision or T/M-Vision);
•
the pinspotter interface;
•
other optional LCOM devices (Bumper interface, Q-FOUL, TMR, etc.);
•
one 4HD/5HD-HUB;
•
one 4HD/5HD-CPU;
•
the overhead monitors (i.e. two overhead monitors);
•
one EasyKey console.
The camera, pinspotter interface and the other optional LCOM devices are connected to the 4HD/5HD-HUB
via the LCOM cable (Refer to section
LCOM Line for further information).
The L1 port of the 4HD/5HD-CPU is connected to the L1 port of the 4HD/5HD-HUB via a network cable.
Each overhead monitor is connected to the corresponding port of the 4HD/5HD-CPU unit with a HDMI cable.
If the monitors do not support commands via the HDMI, a serial communication cable (P/N: 288401007)
must be installed between the overhead monitors and the 4HD/5HD-CPU in order to be controlled directly
from a Conqueror X computer.
The EasyKey Pair is a single EasyKey console on a single pedestal installed on each pair of lanes.