QubicaAMF 400288005, Руководство по установке

Страница: 134 / 147

BES X Dual Mode BES X installation manual
124 P/N: 400288005; Rev: L, 09/21
7. Remove the three (3) remaining retaining screws, finally remove the original table plate and scrap it.
8. Pass the 4- pin cable (“A”) and the cable of the card reader network interface (“B”) through the
pedestal. Pass all the cables through the hole in the card reader plate. Pass the “A” and “B” cables
under the card reader plate through the slots. Fix the plate to the pedestal using three (3) screws as
shown in the image below.
IMPORTANT : Do not fully tighten the screws, keep them lifted from the plate by at least
3
8
” [9 mm].
9. Place the V-Support front on the card reader plate and slide it under the three (3) retaining screws.
Take care not to pinch any wires or cables.