QubicaAMF 400288005, Руководство по установке

Страница: 109 / 147

BES X installation manual System first start-up
P/N: 400288005; Rev: L, 09/21 99
21 In any case (whether if the lane stops in error 203 or if the lane boots-up correctly), set up the correct
pinsetter parameters in Conqueror X.
22
Navigate through the Conqueror X main menu and select:
SETUP / Lane Setup / Pinspotter and Camera .
23
In the Select the destination lane window, choose the first lane where you must load
the parameters and press OK .
24 Press Defaults in order to load the standard values.
25
Once the default values have been loaded, press Send to load them on to the 4HD/5HD-
CPU.
26 Press No when prompted to Reset the Lane Control Box.
27
Press Copy to in order to load the values on all the lanes that have the same pinspotter
and interface type.
28 Select the target lanes, enable the Reset option and press OK .
29 The system will reboot after the parameters have been uploaded.
30 If SuperTouch LCD monitors have been installed, they will start to load the programs.
31 During the load programs procedure, an image with a blue background will be displayed on the
SuperTouch monitors. This means that the procedure is in progress. If an error occurs, an image with
a red background will be displayed and the procedure will stop. If the procedure ends correctly, an
image with a green background will be displayed on the SuperTouch monitors, then the system will
reboot after a few seconds.
32 Once all the lanes are up and running, upload the animations to the lanes. Please refer to the section
How to Upload animations to the 4HD/5HD-CPU units .