Quantum SNC 4500, Руководство пользователя

Страница: 94 / 122

88 Management Port Command Reference
set IdentifyBridge [status]
Enabling the set IdentifyBridge command causes the Fault LED on the front panel of the SNC to blink
until the parameter is disabled. If a fault condition makes the fault LED blink and you wish to turn it off, use
set IdentifyBridge disabled . The default setting is “disabled." Refer to get IdentifyBridge on page 67. This
command takes effect immediately.
Ready.
set identifybridge enabled
Ready.*
set IPAddress [port number] [IP address]
The set IPAddress command designates the IP address of the SNC Ethernet ports if IPDHCP has not been
enabled and where xxx.xxx.xxx.xxx equals the IP address. A saveConfiguration restart command must
be used to permanently save this configuration. Refer to get IPAddress [port number] on page 67. DHCP is
disabled by default. This command must be followed by saveConfiguration restart .
ECC = Error Correcting/Correction Code
ALL = All of the above
Log Level Choices
INFO WARN CRIT FAIL ALL
Where:
INFO = Information
WARN = Warnings
CRIT = Critical events
FAIL = Failures
ALL = All of the above
Status Meaning
enabled The subsystem and log level chosen are masked during event logging
disabled The subsystem and log level chosen are shown during event logging
Status Meaning
enabled Causes the fault LED on the front panel of the SNC to blink
disabled Stops the fault LED on the front panel of the SNC from blinking
Port Number Meaning Default value
dp0 Ethernet data port labeled Ethernet port 0 10.0.0.1
dp1 Ethernet data port labeled Ethernet port 1 10.0.0.2