Quantum SNC 4500, Руководство пользователя

Страница: 27 / 122

SNC 450x User’s Guide 21
Bridge Serial Number = “IPB2500100136”
Bridge Name = “SNC 450x”
Internal Temperature = 25 C [0 - 70]
For help, type HELP.
Active Configuration = ADIC Config File
Feb 4 2004 14:06:50 A61Z Initialization Complete
Scsi interface 0 Register R/W test Passed
Scsi interface 0 Reset test Passed
Scsi interface 0 FIFO test Passed
Scsi interface 0 Master test Passed
Scsi interface 1 Register R/W test Passed
Scsi interface 1 Reset test Passed
Scsi interface 1 FIFO test Passed
Scsi interface 1 Master test Passed
Initializing Port DP0......................
Initializing Port DP1......................
Initializing Port MP0......................
GBE hardware Init done.
Ready.
5 To verify that you have connected successfully, type
help
after the Ready prompt and press Enter.
If a list of all available commands does not appear on the screen, review the steps in this section, check
the cable, or contact service personnel until the problem is solved.
• If you wish to change the default username and password for world wide web, Telnet and FTP use,
continue with the section
Completing the Installation .
• If you are configuring the SNC for the first time, continue with the section Connecting to the Ethernet
Management Port .
• If you were sent to this section by another procedure, return to that procedure.
Connecting to the Ethernet Management Port
The management port IP address (Ethernet port 2, also called the mp0) must be set by issuing a command
from the serial port (refer to
Connecting to the Serial Port on page 18).
1 Using at least Cat 5e cable, connect the Ethernet ports to your network switch.
Note
• In serial port sessions, there is no prompt on the line below the word Ready .
Begin typing commands in the blank line where the cursor is resting.
• No username or password is required for serial port access.
• CLI commands are case insensitive. You can type all upper or all lower case
or a mixture. Upper and lower case in this guide and the Help screen are for
clarification only.
CAUTION
• For best performance, all cabling, network interface cards (NICs),
host bus adapters (HBAs), and network switches must be Gigabit
Ethernet (GbE), and at least Cat 5e certified. Most standard offices
use 2-pair wiring which is not compatible. GbE requires 4-pair
wiring. For best performance, support for 9600 byte jumbo frames
should be available for all switches and host iSCSI equipment.
• It is recommended that you configure host access through a switch.