Quantum SNC 4500, Руководство пользователя

Страница: 37 / 122

SNC 450x User’s Guide 31
• Ensure the SNC is mapped to iSCSI LUN 0.
• Map the SCSI devices with sequential IDs starting at 0 for each device.
4 Click Submit.
All the CLI commands necessary to enable mapping and the command saveconfiguration
norestart will be performed.
• If devices are not properly displayed, open the SNC Manager Advanced page. In the Enter a CLI
command text box, enter the SCSITargets command to make sure all devices are online. Then
enter the autoMap command.
• If devices are not properly displayed, you can use the SNC Manager Advanced page and the route
command to manually map devices. Use the route command if devices have not been discovered
in order by the autoMap command. The LUN IDs should be in the order of the SCSI IDs.
• For detailed troubleshooting procedures, refer to Troubleshooting on page 41.
• If devices still are not properly displayed, contact ATAC.
5 Go to the Restart page.
6 Click Restart to make permanent any changes you have made since the last firmware restart.
Restarting the firmware can take a few minutes. Refer to firmwareRestart on page 62.
Other Ways of Connecting to and Monitoring the SNC
Using Telnet
Up to three Telnet sessions can be conducted simultaneously. A serial port session can use the CLI while
Telnet sessions are open. Whichever session issues the first “set” CLI command can continue to issue set
commands, while the other sessions can only issue “get” commands or display information. Once a
connection is established, refer to
Using the Command Line Interface (CLI) on page 51 for lists of valid
commands.
1 Connect to the SNC from a computer on the same Ethernet network.
2 Start a Telnet session.
3 At the Telnet prompt, issue the open command:
telnet > open x.x.x.x
where x.x.x.x is the IP address of the SNC.
4 If you have to specify a port type, enter the port type
telnet
and the terminal type
vt100
.
Note
The recommended management tool for the SNC 450x is the SNC Manager
interface.
Note
There is more than one way to connect to the SNC using a Telnet
program.Your Telnet program may operate differently than in the following
instructions.
Note
To obtain the IP address of the SNC, refer to the information you recorded after
completing
Step 2 on page 22 in the section Connecting to the Ethernet
Management Port on page 21.