Chapter 2 Installation Procedures
Installing the Internal LTO-4 (Model B) Half-Height Tape Drive
10
LTO-4 (Model B) Half-Height Tape Drive User’s Guide
back panel to change the SCSI ID of the LTO-4 (Model B) Half-Height
Tape Drive (see
figure 2
).
Note:
Parallel SCSI controllers and host adapters generally use ID 7. In
some systems, the boot drive uses ID 0 or ID 1. Avoid
configuring the LTO-4 (Model B) Half-Height Tape Drive to these
SCSI IDs.
Figure 2 Internal Parallel SCSI
ID Configuration Jumper Pins
Configuring the Internal Parallel SCSI Terminator Power
By default, terminator power is enabled on the internal parallel SCSI
LTO-4 (Model B) Half-Height Tape Drive. If you use this default setting,
then the last device at the end of the parallel SCSI bus must have either:
• A parallel SCSI bus terminator
• Terminator power enabled
See
figure 3
for examples of internal parallel SCSI bus termination.
SCSI ID 2
SCSI ID 3
SCSI ID 5
SCSI ID 9
SCSI ID 13
TP NC 8 4 2 1
TP NC 8 4 2 1
TP NC 8 4 2 1
TP NC 8 4 2 1
TP NC 8 4 2 1
Содержание LTO-4 (Model B)
