Quantum LTO-4 (Model B), Руководство пользователя

Страница: 24 / 98

Chapter 2 Installation Procedures
Installing the Internal LTO-4 (Model B) Half-Height Tape Drive
8 LTO-4 (Model B) Half-Height Tape Drive User’s Guide
Unpacking and
Inspecting the Drive
Although each LTO-4 (Model B) Half-Height Tape Drive is inspected and
carefully packaged at the factory, damage can occur:
• In shipment
• When being unpacked
Observe the handling precautions listed in Handling Precautions and
Installation Guidelines and carefully unpack and inspect the LTO-4
(Model B) Half-Height Tape Drive as follows:
1 Visually inspect the shipping container and notify your carrier
immediately of any damage.
2
Place the shipping container on a flat, clean, stable surface and
carefully remove the contents.
3 Visually inspect the LTO-4 (Model B) Half-Height Tape Drive and
notify your Quantum representative immediately of any damage.
4 Always save the shipping container and packing materials for any
future reshipment.
Installing the Internal LTO-4 (Model B) Half-Height
Tape Drive
To install the internal LTO-4 (Model B) Half-Height Tape Drive, complete
the following procedures in the order presented:
1 Depending on the interface configuration of the drive:
IF the drive interface is . . . THEN . . .
parallel Small Computer
System Interface (SCSI),
proceed to Configuring the
Internal Parallel SCSI Tape Drive in
the following subsection to
configure the parallel SCSI ID and
bus terminator power.