Quantum FastStor 1, Руководство пользователя

Страница: 24 / 78

2. Secure the cable with the thumbscrews on the connector.
3. Connect the other end of the SCSI cable to the appropriate SCSI adapter on
your system, and fasten it with the thumbscrews.
4. If the FastStor 1 is the last device on the SCSI bus, install a SCSI bus
terminator to the free SCSI connector on the FastStor 1. Make sure the
terminator is of the correct type for your SCSI system.
5. It is possible to daisy chain several SCSI devices on the SCSI bus. If you do
so, the terminator must be connected to the last device on the bus. Note
that there are limitations to the SCSI cable length.
Figure 3.10 SCSI cable and SCSI terminator connection
Step 8. Connecting the Ethernet Connector
To connect the FastStor 1 to the Ethernet, use the provided cable from the
accessory kit box.
1. Insert one end of the cable into the FastStor 1 Ethernet port. Push until it
snaps into place. The open port in Figure 3.10 is for Ethernet connection.
2. Connect the other end to a normal 10/100 BaseT Ethernet outlet.
The Ethernet-based Remote management system is described in Remote
Management.
Step 9. Restarting Your System
ADIC recommends that all external SCSI devices, including the FastStor 1, are
powered on before the computer system is re-started. After restarting your system,
including the FastStor 1, the FastStor 1 runs a power up self-test (described in
Step 5). When the display reports that the FastStor 1 is in the “Idle“ state and the
green LED is on, the FastStor 1 is ready for further configuration and operation
(described in Operation and Configuration).
Note: The tape drive needs up to 40 seconds after power on until it’s active on the
SCSI bus. You should turn on the power at least 40 seconds before the computer
18 FastStor 1 Installation and User Guide