UANTA COMPUTER INC.
Layer 2/3/4 Managed Switch
_____________________________________________________________________________
LB9
User’s Guide 728/1523
7.3.2.23
bandwidth
By default, OSPF computes the link cost of an interface as the ratio of the reference bandwidth to the
interface bandwidth. Reference bandwidth is specified with the
auto-cost
command. For the purpose of
the OSPF link cost calculation, use the bandwidth command to specify the interface bandwidth. The
bandwidth is specified in kilobits per second. If no bandwidth is configured, the bandwidth defaults to the
actual interface bandwidth for port-based routing interfaces and to 10 Mbps for VLAN routing interfaces.
This command does not affect the actual speed of an interface. Use
no bandwidth
command to set the
interface bandwidth to its default value
Syntax
bandwidth <1-10000000>
no bandwidth
Default Setting
Actual interface bandwidth
Command Mode
Interface Config
7.3.2.24
capability opaque
Use
capability opaque
command to enable Opaque Capability on the Router. The information
contained in Opaque LSAs may be used directly by OSPF or indirectly by an application wishing to
distribute information throughout the OSPF domain. Supports the storing and flooding of Opaque LSAs
of different scopes. Use
no
capability opaque
command to disable opaque capability on the router
Syntax
capability opaque
no capability opaque
Default Setting
Disabled
Command Mode
Router OSPF Config Mode