QERIDOO Kidgoo Pro, Руководство пользователя

Страница: 36 / 44

36
Caution!
Replace corroded steel and aluminium parts immediately.
Never bend back deformed or bent aluminium parts
(danger of breakage). Replace bent aluminium parts
immediately. Immediately replace plastic parts that
have become porous or fragile due to the effects of the
weather, for example.
»
Check that the wheels are secure. The push-in axles must be en -
gaged in the axle mount and it must not be possible to pull them off
without pressing the rubber cap.
»
Check the air pressure in the wheels. It should be in the range of
2.5 – 3 bar.
»
Check the air pressure of the buggy wheel (maximum air pressure:
1.9 bar).
»
Check the total weight, including children and baggage.
»
Check the fasteners of the cover and close them if necessary.
»
Inspect all harnesses on the back and under the cabin to make sure
that they are secure.
They must be firmly tightened to hold the cover and backrest
securely.
»
Trailer mode: Make sure that the buggy wheel has been removed
and that the requirements described in the chapter „Connecting the
trailer to a bicycle“ on page 30 have been fulfilled.
»
Buggy mode: Make sure that the buggy wheel can rotate freely.
Put the hand strap of the push handle around your wrist in order to
prevent accidental rolling away.
»
Jogger mode: Make sure that the buggy wheel is secured facing
straight ahead. Put the hand strap of the push handle around your
Before every ride
wrist in order to prevent accidental rolling away.
»
Check whether the tow bar, coupler and buggy wheel and their
attachments are technically OK.
»
Check the condition of the wheels. Replace covers and hoses in
good time.
»
Check the textile cover, all fasteners, the seats and the safety
harnesses for cracks, wear and missing parts.
»
Inspect all frame tubes and all connecting pieces and fastening
components for signs of wear and damage.
»
Check that all screw and cotter pin connections are secure.
»
Clean the thru-axles of the wheels and additionally spray them with
silicone spray.
Monthly (or every 200 km)
»
Care for all sliding and moving parts with silicone spray.
»
Clean the inside and outside of the cabin thoroughly.
»
Check the spoke tension, which must be between 90 and 100 kg.
Semi-annually (or every 500 km)
»
Have a full inspection carried out by a specialist workshop no later
than every three years.
»
Change the red leaf spring plates (wear parts).
Every four years (or every 5�000 km)
Every three years (or every 3�000 km)
»
Replace the thru-axles.
CARE AND MAINTENANCE
Maintenance intervals