Wall Mounting:
Ensure the wall is strong enough to withstand the weight of the battery modules.
Step 1: Fix the wall bracket (C1) onto the wall
Ÿ
Use the wall bracket as a template to mark the position of 5 holes
Ÿ
Drill holes with a drill. Ensure the holes are deep enough (at least 1.97in)
for installation and tighten the expansion screw sleeves
Ÿ
Install the expansion screw sleeves (E1) on the wall and screw in the bracket
by using a wrench
Step 2: Remove the upper installed hanging board
Step 3: Match the battery module with the wall bracket
Ÿ
Transport the battery module to the wall bracket
Ÿ
Hang the battery module over the wall bracket, position the battery module
close to it, and match it on the wall bracket
Step 4: Lock the joint between the hanging board and the wall bracket with the
M5
combination screw (F1)
The following figure shows the back view of the wall mounting installation
4.5
Cable Connection
4.5.1
Connecting Power Cables
For one battery module:
The color at both ends of the power cable between the BMS and battery
module (C) is orange. This cable is connected to the XPLUG which is on the left
side of the BMS (II) and battery module (I').
2) Ensure that both ends of the power
cable are connected to the correct connector,
which are on the left side of the BMS and battery
module.
Overview of Step 2 and Step 3:
18
19
4. Installation
4. Installation
Note:For wall mounting, the distance between the bottom of battery module and floor
shall not exceed 11.81in.
1) Plug either the end of the power cable to the
XPLUG on the BMS (II) and battery module (I').
When the metal sheet (indicated in red below)
is totally inserted and a click sound is heard,
that means the power cable is completely
connected.
3) After the battery module has been correctly
connected,
plug the Series-Connected Plug (F)
at the right side of battery module (V’) to make a
complete circuit.
INSTALLATION AND OPERATION MANUAL LITHIUM-ION BATTERY – Q CELLS
INSTALLATION AND OPERATION MANUAL LITHIUM-ION BATTERY – Q CELLS
3
.
28ft
11.81in
