Pulsar dBi-M, Инструкция по эксплуатации

Страница: 25 / 71

PULSAR MEASUREMENT
25
The best way to obtain a hard copy of your parameter list is to print the
parameters to a file (save as a .doc file). The list can then be printed out at
your convenience.
Trace
The Trace menu gives you four options:
1. Save trace images to file captures the current echo trace displayed on
the graph and save it as a .jpg file.
2.
Save trace to clipboard, saves the current viewed echo profile onto
your clipboard, from there it can be pasted into a document such as
word for recording, viewing, or reporting.
3. Print echo traces will open a preview of the current displayed profile
which you can alter to suit your requirements before printing.
4. Zoom full allows you to zoom out to the maximum range, enabling
you to view the echo trace being displayed on the main graph.
Tools
The Tools menu enables you to open up the Comport settings window,
enabling you to select the comport that the dBi-M is connected to. Or if a
dBi-M is already connected to the PC software, you can close the com port
ending your session with the dBi-M series intelligent transducer.
Re-program option will be greyed out as this requires service access, this will
allow you to re-program the dBi-M with up-to-date firmware. Please consult
Pulsar Measurement for assistance in carrying out this operation.
Modbus Poll allows you to view the Modbus register information in the dBi-
M Series Intelligent Transducer. Function allows you to select between
Function 03 - Holding Register (Runtime registers) which are read only, and
Function 04 - Input Register (Configuration parameters) which are
read/write.
The address is used to select the register address that you wish to view/edit.
Please refer to
Chapter 6 Modbus for a full list of available registers for the
dBi-M Series Intelligent Transducer.
And the length of bytes is set to 4 as every register is in a 32-bit float format
(which is 4 bytes in length), and are formatted as Little Endian.