Chapter 2: Create Your Disk Array
7
Create a Security Array with New Drives
Use this setting to create a Mirrored (RAID 1) array with two new hard drives. If
one of the drives has data on it, follow the
Creating a Security Array with an
Existing Data Drive
procedure on the next page.
Note
When creating a Security array with new drives, a feature called
Gigabyte Boundary will automatically be set to ON. For a
description of this feature, see page 19 in this Manual.
To create an array for data protection using new hard drives, follow these steps:
1. Press the Spacebar to choose
Security
under the Optimize Array for
section.
2. Press Ctrl-Y to Save your selection.
3. The window below will appear.
Do you want the disk image to be
duplicated to another or do quick
initialize or create only?
Y - Create and Duplicate
N - Create Only
I - Create and Quick Initialize
4. Press N for the Create Only option.
5. A window will appear almost immediately confirming that your Security array
has been created. Press any key to reboot the system.
Array has been created.
<Press Any Key to Reboot>
6. Proceed with normal FDISK and format procedures as if you had just
installed a new hard drive.
7. Once the arrayed drives have been formatted, proceed to Chapter 4 of this
Manual to install your operating system and/or driver.
Содержание PDC20319
Страница 1: ...PDC20319 SATARAIDCONTROLLER USER MANUAL Version 1 3...
Страница 42: ...PDC20319 SATA RAID Controller User Manual 38...
Страница 58: ...PDC20319 SATA RAID Controller User Manual 54...