ProMinent DULCOTROL DWCa, Руководство по сборке и эксплуатации, Страница: 64 / 140

3. Wait for the controller's module scan
Module scan
A1081
Base module
Expansion module
continue with <OK>
Softw. version: 01.00.00.00
Softw. version: 01.00.00.00
Auto continue in 10 s
Fig. 30: Module scan
ð
The controller indicates the controller modules installed
and identified.
4.
Press
ð
The controller now changes to its continuous display.
From the continuous display, you can access all the con‐
troller's functions using .
12.1.2 Adjusting the backlight and contrast of the controller display
Continuous display ➨ ➨
[Setup] ➨ [Device setup]➨ or
[Device configuration] ➨ [Backlight]
Under this menu item you can set the brightness and contrast of
your controller display to match the ambient conditions at your
installation location.
12.1.3 Resetting the operating language
Resetting the operating language
In the event that a foreign and hence incompre‐
hensible operating language has been set, the
controller can be reset to the basic setting. This is
implemented by the simultaneous pressing of the
and keys.
If you no longer know whereabouts you are in the
operator menu, you must press the key as often
as necessary until the continuous display becomes
visible again.
12.1.4 Defining metering and control processes
Set the controller once you have integrated it into the control cir‐
cuit. Setting the controller adapts it to your process.
Define the following parameters to set up a controller:
n
What type of a process is planned?
n
Which measured variables are there?
Commissioning the controller diaLog DACb
64