BS61M
series
~31~
Floppy Cable
The cable for the floppy drive is a 34-pin flat cable with five connectors:
•
One female header (for the onboard floppy connector)
•
One female header for drive A
•
One edge connector for drive A
•
One female header for drive B
•
One edge connector for drive B
The end-most connector cable is twisted to support floppy drive A,
while the middle connectors are for floppy drive B. The drive B connectors
are designed to accommodate both 1.44MB and 1.2MB drives. The female
header supports 1.44MB drives, while the female edge connector supports
1.2MB drives. When connecting the cable to a drive, make sure that pin1 of
the cable (i.e., the red wire) matches pin1 on the drive connector.
IDE Cables for HDD and CDROM
Your motherboard comes with two IDE interfaces —a primary and a
secondary connector. Each channel supports two IDE devices via a 34-pin
flat cable, and the system is capable of supporting a maximum of four
devices.
Note:
If you want to connect any ATA66 device on IDE Port, please use the
specified cable of ATA66. Regarding to the relate information of ATA
devices, please refer the instruction of ATA66 devices supplier.
KQ
2
KQ
3
KQ
4
KQ2
KQ
3
KQ4
KQ2
KQ3
KQ4
KQ2
KQ
3
KQ4
FAN
1
FAN
2
3V
B
a
tte
ry
KQ
2
KQ
3
KQ
4
KQ
2
KQ
3
KQ
4
KQ
2
KQ
3
KQ
4
KQ
2
KQ
3
KQ
4
FAN
1
FAN
2
3V
Ba
tt
e
ry