probrand ProTechT XMME-KIT00, Инструкция по установке и руководство пользователя

Страница: 12 / 32

12
• Select one of the following wire management methods for the antenna cable:
Method One:
• This requires no hole through the boat for the antenna wire. The wire will be routed
on the surface where the antenna mounting flange is located.
• Weave the pig-tail of the XM marine antenna through the center hole of the flange
mount adapter then attach the flange mount adapter to the XM marine antenna
using the four M4 x 0.7 x 10 Philips pan head stainless steel screws (with blue sealant).
• Route the XM marine antenna cable under the groove in the base of the flange
mount adapter (see Figures #5a and #5b). Take caution not to crimp the antenna ca-
ble under the flange mount adapter as you tighten down the flange mount adapter.
The cable must be in the groove on the bottom of the flange mount adapter.
Figure #5a Figure #5b
• Next, locate the black, round, flat foam gasket affixed to the paper backing. Gently
peel the gasket from the backing. Place the sticky side toward the antenna wire in
the groove in the flange and affix the gasket to the mating channel in the flange.
Press the gasket firmly into place.
• If the surface that you choose for your XM marine antenna is wood or fiberglass, use
the four supplied #8-18 x ¾ stainless steel, self-tapping screws for firmly mounting the
antenna to the chosen surface.
ProTechT XM
Marine Antenna
Part F
Flange
Mount
Adapter
Part U
M4x0.7x10 Philips
pan head stainless
steel screws
Part Q
#8-18x3/4 Philips pan head
stainless steel screws
Part P