pro.point 8843740, Инструкция по эксплуатации

Страница: 8 / 40

8843740 1/4 in. Air Riveter V1.0
8 For technical questions call 1-800-665-8685
5. Slowly press the syringe plunger down
until the oil is in the tool.
5.1 The reservoir is full if it becomes
difficult to push the plunger down.
Pull the plunger up slightly to
withdraw a little oil, then unscrew the
syringe.
6. Remove the syringe and brass fitting.
Tighten the screw on top of the oil
cylinder. Wipe the cylinder clean.
NOSEPIECES
1. Select the appropriate sized nosepiece (A) for your task.
2. Insert the nosepiece into the jaws (#54) within the outer sleeve (B).
3. Fit the wrench’s center hex over the nosepiece and twist clockwise
(view from front) to lock it in place. Remove the wrench.
RIVET SUCTION ADJUSTMENT
The air riveter has a feature that sucks a rivet into the nosepiece for
quicker loading. An o-ring seals the airflow opening to prevent airflow.
Turning the rivet suction knob (D) allows suction to form at the
nosepiece.
1. Remove the safety cap (E).
2. Turn the rivet suction knob counterclockwise half way round to start
the airflow.
3. Reset the safety cap.
4. An audible hiss can be heard from the nosepiece.
5. Place the nosepiece next to the rivet pin to suck the rivet into the
nosepiece.
6. Turn the rivet suction knob clockwise to stop the suction airflow.
Make sure to shut off the air supply first.
REPLACING SMALL RIVET MANDREL CONDUIT
Replace the rivet mandrel conduit (#53) with the narrow version (#59)
when using rivets that are 5/32 in. or narrower.
1. Remove the outer cylinder (#56) with the wrench’s (#58) open end.
Fig. 2
2-1
2-2