pro.point 8843740, Инструкция по эксплуатации

Страница: 9 / 40

V1.0 1/4 in. Air Riveter 8843740
Visit www.princessauto.com for more information 9
2. Unscrew the jaw carrier (#55) by rotating counterclockwise and set
aside. Be careful not to spill the jaw assembly.
3. Pull out the rivet mandrel conduit.
4. Insert the small rivet mandrel conduit. Refit the jaw carrier and
outer cylinder tightly.
OPERATION
WARNING! Always fit the safety cap to the rear of the air riveter
before use to prevent a penetrating injury from an ejected rivet
mandrel.
CAUTION! Keep fingers away from the trigger (F)while inserting
the rivet into the air riveter. Accidental activation may cause a
cut or pinching injury.
One or more holes of the same diameter as the rivet must be drilled
into the workpiece before installing the rivets.
1. Check the hydraulic oil level before each use (See Adding
Hydraulic Oil).
2. Select the correct nosepiece based on the rivet diameter and install
per Nosepieces section.
3. Attached the air riveter to the air source and start the compressor.
4. Push the rivet mandrel (stem) through the nosepiece until the rivet
head touches the nosepiece.
5. Insert the mandrel head and rivet pin into the pre-drilled hole. Push
the nosepiece against the workpiece.
6. Squeeze the trigger. The mandrel head will compress the rivet pin
while the mandrel is pulled through the air riveter. The force will snap
the mandrel at the rivet head and eject the scrap mandrel into the
safety cap.
7. Repeat Steps 4 to 6 until all rivets are installed.
8. Shut the compressor down and discharge all air from the system
before changing the nosepiece for a different diameter rivet.
9. Empty the safety cap when necessary. Make sure a rivet is not
inserted into the nosepiece when emptying the cap as an ejected
mandrel may cause a penetrating injury.