pro.point 8843740, Инструкция по эксплуатации

Страница: 11 / 40

V1.0 1/4 in. Air Riveter 8843740
Visit www.princessauto.com for more information 11
7. Press the piston and air cylinder cover assembly back into place as
far as possible. Tighten the nut.
8. Refit the cylinder base cover onto the air cylinder.
ADJUSTING THE STROKE LENGTH
1. Remove the outer cylinder (#56) using the open end of the wrench .
2. Measure the distance between the clamp nut (#51) to the oil
cylinder’s face. Adjust the distance if it is not 60 mm.
3. Slide a wrench over the jaw carrier’s flats.
4. Slide a wrench onto the clamp nut (#51).
5. Hold the jaw carrier in place while loosening the nut.
SHORTEN THE DISTANCE
5.1. Spin the nut backwards to shorten the distance until it is
60 mm away from the oil cylinder face.
5.2. Rotate the jaw carrier until it touches the nut.
5.3. Hold the jaw carrier secure and tighten the impact nut.
INCREASE THE DISTANCE
5.4. Spin the jaw carrier forward to increase the distance from the
oil cylinder.
5.5 Spin the clamp nut forward until it is 60 mm away from the oil
cylinder face.
5.6 Rotate the jaw carrier until it touches the nut.
5.7 Hold the jaw carrier secure and tighten the impact nut.
6. Fit the outer cylinder back onto the air riveter and tighten.
CLEANING AND CHANGING THE JAWS
1. Remove the outer cylinder with the wrench’s box end.
2. Loosen the clamping nut, then unscrew the jaw carrier from the
principal axis (#43).
3. Remove the jaw assembly (#54) from the jaw carrier and set the latter
aside.
4. Clean the jaws with mild solvent and a brush. Dry and inspect for
damage. Replace the jaws if they are blunt.