l
Stop pedaling and wait for the pedals to completely stop. Wait 10 seconds to allow
the bike to complete the power measurement auto-cal function.
l
While continuously pedaling the bike at 60 RPM, verify that the measured
workout WATTS at minimum and maximum resistance levels is within spe-
cification.
Resistance Level
Power (WATTS)
minimum
≤ 40 Watts @ 60 rpm
maximum
≥ 415 Watts @ 60 rpm
Power (WATTS) specification
IMPORTANT
: The bike must be auto-cal'd before making the WATTS meas-
urement. Also, the bike must be continuously pedaled between the min and max
resistance WATTS measurements. If the pedals stop, a new auto-cal may occur
invalidating the measurements.
Generator verification:
(Spinner
®
Chrono™ Power only).
l
Pedal the bike at 60 RPM.
l
Verify that the measured generator voltage (service menu GEN VOLT) and cur-
rent output (service menu GEN AMP) is within specification.
Generator Spec
Power (WATTS)
Generator voltage (GEN VOLT)
approx: 9 Vac @ 60 rpm
Generator current (GEN AMP)
approx: 0.4 amps @ 60 rpm
Generator specification
Error Log &
ASL
1
verification:
(Spinner
®
Chrono™ Power only).
l
Verify that there are no current active error codes, view the service menu
ERROR LOG. If there are logged error codes, resolve them and clear the error
log (service menu CLEAR ERROR
l
Verify the ASL blue state (Some facilities may choose to switch the ASL function
OFF, see ASL SETUP): Ride the bike and stop. Make sure that the console ASL
state is steady blue. If not, resolve any issues and reset the ASL to blue state.
Return to service
(Spinner® Chrono™ Power models only)
l
Auto-cal the bike, set the resistance level to minimum, start pedaling greater than
55 rpm and then stop pedaling. Wait for the pedals to stop and dismount the bike.
l
If verification tests were successfully completed, return to service.
1
Active Status Light: Service and maintenance status light.
8
3 Operation Verification
Operation Verification Checklist
Содержание Spinner Chrono
