Precor Spinner Chrono, Руководство по обслуживанию, Страница: 90 / 166

2. Slide the handlebar forward enough to allow access to handlebar assembly travel limit
set screw located at the back end of the handlebar post slider. Reinstall the rear slider
travel limit set screw using a 2.5 mm hex key.
3. Reinstall the rear handlebar post slider end cap and secure using the two mounting 2.5
mm hex key bolts.
4. (Spinner® Chrono™ Power models only)
Position the console on the handlebars and connect the data COMM cable. Adjust the
cable slack and reinstall the console backplate, secure using the four hex key bolts (4x)
(see the "SPINNER
®
CHRONO™ CONSOLE" Operator's Guide ).
5. Verify the handlebar forward/back travel is smooth and that the handlebar slider is
stopped from sliding off the post slider by the travel limit screw. For Spinner® Chrono™
Power models, verify the data COMM cable has enough slack for handlebar minimum
to maximum travel adjustment.
6. Verify the handlebar adjustment knob operation and that it holds the handlebar in pos-
ition.
See Also
"Handlebar Adjustment Knob Replacement" on the next page
83