10. (Spinner® Chrono™ Power models only)
If the cross member cable ties were removed, replace them with new cable ties to
secure the generator, data COMM, strain gauge , and battery interface cables to the
cross member (4x locations).
11. Place the generator belt onto the generator and flywheel generator pulleys. Place the
belt onto the smaller generator pulley and walk the belt onto the larger flywheel gen-
erator pulley
12. Adjust the drive belt tension and tracking to specification, go to
Tracking Adjustment" on page 16
13. If the axle nuts were not previously tightened to specification, tighten the left and right
axle nuts torque to 29.5 ft-lbs (40 Nm).
14. Adjust the generator belt tension to 1/2 in (1.3 cm) up/dwn travel, see
76
5 Replacement Procedures
Drive Belt, Generator Belt, and Flywheel Replacement
Содержание Spinner Chrono
