Precor 9.45, Руководство по обслуживанию

Страница: 2 / 58

9.45, 9.45i Treadmill
Page 2
Section One
- Things you Should Know
About This Appendix
Precor has re-designed the M9.45 treadmill several times. Units with the original design have
serial numbers starting with '1L' and were manufactured between January 24, 1995 and March
25, 1996. The M9.45 treadmill was then redesigned with serial numbers starting with '2P' and
were manufactured between March 26, 1996 and November 15, 1997. The 9.45i uses serial
numbers starting with ‘3Y’ and started in production on November 16, 1997. The 9.45i is the only
version of the 9.45 that is currently in production. This document will refer to the three versions
as follows 9.45 (1Y), 9.45 (2P) and 9.45i (3Y).
Section One, Things You Should Know
. This section includes general information and
technical specifications. Read this section, as well as the M9.45 Treadmill Owner’s Manual,
before you perform the maintenance procedures in this manual.
Section Two, Software Features
. Precor’s M9.45 Treadmill is programmed with several
diagnostic and setup features. This section contains the procedures you need to access the
diagnostic features on this treadmill.
Section Three, Checking Treadmill Operation
. This section provides you with a quick way of
checking treadmill operation. Check treadmill operation at the end of a maintenance procedure
and when it is necessary to ensure that the treadmill is operating properly.
Section Four, Inspection and Adjustment Procedures
. Perform inspection procedures when
a trouble symptom points to a particular problem and after removing and replacing major
components. Many maintenance problems can be fixed by adjusting various treadmill
components. This section also provides you with the step-by-step procedures required to make
these adjustments.
Section Five, Troubleshooting Procedures
. The diagnostic and troubleshooting procedures
contained in this section should be performed when it is necessary to isolate a problem to a
particular component.
Section Six, Replacement Procedures
. When a treadmill component must be replaced, go to
this section and follow the step-by-step procedures required to remove and replace the
component.
Section Seven, Wiring and Block Diagrams
. This section includes wiring and block diagrams
for all versions of the 9.45.
General Information
For the latest exploded view, part number and part pricing information, visit the Precor dealer
website at “www.precor.com/Dealer”.