8 Modes of operation and operating
■
17
En
gl
is
h
• With anti-theft encoding deactivated, the balance can be switched on again and operated after interruption
of the power supply without entering a code.
• With anti-theft encoding activated, the balance requires the entry of the four-figure code after each inter-
ruption to the power supply.
• If the code is input incorrectly, the balance is blocked.
• If the balance is blocked, it must first be disconnected from the power supply, then reconnected and un-
blocked by entering the correct four-figure code.
• After seven consecutive incorrect entries the display will read “NO ACCESS, CALL SERVICE”. In this case,
only service can unblock the balance again.
To activate the anti-theft encoding and to alter the code programmed in the works to one which you have
chosen yourself, see Chapter 9.10 “Anti-theft encoding”.
NOTE
The anti-theft-encoding is deactivated in the works.
The
pre-programmed code
set by the works is:
8 9 3 7
This code is the same for all balances. For reasons of security you should therefore always select your
own code.
Keep your personal code in a safe place.
