PAS26R CROSSOVER AUTOMATIC SCRUBBER
12
Lift the brush plate before proceeding with transport. Place the machine on a pallet, taking care to lock the wheels to prevent
the machine from moving.
Transport and any lifting must be done with the machine on a pallet. It is recommended to empty the solution recovery tanks.
If the automatic scrubber is loaded on a vehicle via a ramp, or in any situation where it is required to drive it on a steep ramp,
it is recommended to lift the brush plate and take down the splash-guards and brushes.
This automatic scrubber is a Scrubber-Dryer machine, driven by an operator seated on board, to wash and dry hard
floors and is battery powered; intended for commercial use.
The machinery applies a detergent solution to the hard floor, a solution that is collected in the solution tank and is
conveyed through suitable piping to the brush plate. With solenoid valve adjustable flow, it scrubs the floor by the
combined action of two counter-rotating brushes and then draws the dirty water into the recovery tank.
It is also possible to spray the floor with water, actuating the brushes only for scrubbing and cleaning, without drying.
The automatic scrubber can be handled without the brush plate lowered and the brushes being in contact with the
floor, or with the vacuum motor turned off. This can happen during transfer from one room to another, at the end of the
cleaning or for other reasons. It is required to set the appropriate controls to raise the brush plate and drive the machine
with brake and accelerator. At this stage; the maximum speed adjustment system is not activated, but the speed is
controlled solely by the accelerator pedal. When moving the machine when the operator is not on board or needing to
push or pull the washer-dryer, with traction motor turned off, turn the red lever on the axle of the rear gear reducer by
pulling it towards the rear of the machine.
Thus, the gears of the motor reducers are at idle and the machine can be moved easily. Remember to rotate the red
lever toward the front of the machine if you want to activate the motor-reducer the drive system of the machine.
The machine is not intended for outdoors use.
Do not wash and extract corrosive, flammable, explosive liquids, even if diluted.
Do not use the machine in environments with explosion hazard or where there are flammable and explosive gases,
vapors, liquids and powders.
Do not wash the floors with water hotter than 50°C/122°F.
Do not use diesel fuel/benzene or corrosive detergents for washing floors.
In addition to this instruction manual, the machine is supplied with a kit containing: 1 clean-water tank filling hose
6. MACHINE TRANSPORT AND LIFTING
7. INTENDED USE OF THE MACHINE
(washing and drying phase)
8. INTENDED USE OF THE MACHINE
(machine being moved without washing or drying)
9. INCORRECT USE OF THE MACHINE
10. SUPPLIED KIT
WARNING
WARNING
https://harrissupplyind.com - To Order Parts Call 608-268-8080
