PAS26R CROSSOVER AUTOMATIC SCRUBBER
22
1. Place the machine in a clean and well-ventilated area, near a battery
charger.
2. Lift the upper tank to access the battery compartment.
Before leaving the machine unattended or performing any maintenance
operation, ensure it is on a flat surface, engage the parking brake, turn off the
machine and remove the key.
3. After ensuring it does not contain any water, tilt the upper tank.
4. Check electrolyte level in every battery element. Before charging the
battery, add a sufficient amount of water to cover the plates. After completing
recharge, add a sufficient amount of water to bring the water level to the
gauge level. If the water level is too high before charging, the normal
electrolyte expansion may cause it to leak, which causes loss of acid
balancing and machine damage.
5. Replace battery caps.
6. Disconnect the battery connector from the machine. Disconnect the battery
charger from the power outlet.
When charging the batteries, connect the battery charger to the lower battery charger socket before connecting it to the
power outlet. Never connect the battery charger to the power outlet first as sparks might be generated.
7. To charge the battery pack, use a DC 24 V battery charger that automatically switches off as soon as the batteries
are completely charged.
8. Connect the battery charger to the lower battery charger socket. Connect the battery charger cable to the power
outlet. The charge indicator shows that the batteries are charging.
9. When the batteries are completely charged, disconnect the battery charger from the batteries.
10. Connect the batteries to the machine connector.
11. Check electrolyte level. The level must reach the gauge. If necessary, add distilled water.
12. Lower the upper recovery tank into its position.
The brush plate is pre-shaped for optimal adherence to the floor. There is the
option of adjusting the brush plate pressure on the ground, to have a lighter
or heavier scrubbing action.
The switch controls the pressure exerted on the floor by the brushes. To
decrease pressure, press the top of the switch. To increase the pressure,
press the bottom part of the switch and check the LED display that indicates
the pressure exerted by the brushes on the floor.
Green means: Light Brush Pressure
Yellow means: Medium Brush Pressure
Red means: Heavy Brush Pressure
FOR SAFETY
FOR SAFETY
15.2. CHARGING THE BATTERIES
15.3. BRUSH PLATE ADJUSTMENT
https://harrissupplyind.com - To Order Parts Call 608-268-8080
