PAS26R CROSSOVER AUTOMATIC SCRUBBER
17
1. Place the vehicle near a floor drain. The discharge pipe is in the left front corner of the machine, under the tank.
2. Turn the ignition key to “OFF”, the parking brake is engaged.
3. Remove the clip from the small discharge pipe connected to the solution tank. The pipe is underneath the machine,
on the left side. Lower the pipe toward the drain, turn on the valve.
4. Wash the tank with clean water and run clean water into the system, until reaching tank capacity (20 gal). Do not use
water at a temperature higher than 120ºF to clean the tank as it might cause damage.
NOTE: Never leave the solution inside the tank as it might damage the tank, the seal gaskets and the solenoid valves.
6. Replace the discharge pipe.
Dirty water drain hose
Circuit breakers panel adjustment knob for
maximum working speed
14. CONTROLS
1
10
8
9
3
2
7
4
5
6
11
13.6. EMPTYING AND CLEANING THE SOLUTION TANK
14. CONTROL STATION
https://harrissupplyind.com - To Order Parts Call 608-268-8080
