PAS26R CROSSOVER AUTOMATIC SCRUBBER
24
Two blades are assembled: one on the front and one on the rear. They are built so as to avoid installation errors.
The squeegee picks up the water from the floor through a vacuum chamber that generates inside it.
In order to achieve maximum vacuum, plastic material drying blades (various types) are fitted that allow it to perfectly
adhere to the floor with no vacuum losses. Blade replacement is therefore required to prevent decrease of water
extraction properties by the squeegee.
To replace the blades:
1. Loosen the two knobs, on the right and left, that lock the squeegee and aim it outward in order to make access easy.
Remove the squeegee and place it on a work bench.
2. Loosen and remove the hand wheels that fasten the blade.
3. Remove the fastening strap and the blade, then rotate upside down or completely replace the blade.
4. The same blade can be used 4 times; each time causing it to work on a different edge (you should turn them every
20 working hours).
5. Fit the blade and fastening strap on the reference pins, then screw the hand-wheels on again.
6. Replace the squeegee.
The clean water filter is fitted under the machine’s floor, on the right side. Its
position is also indicated by the wording on the right side of the solution tank.
The filter has the purpose of preserving the solenoid valve controlling solution
flow rate from any debris or sediment there might be in the solution tank.
It is recommended to clean the filter weekly.
In order to clean it, unscrew the cup, remove the filter inside it and wash it
under running water. Replace it and fit the cup back in.
The filter also acts as a shut-off valve on the solution tank, that is by
unscrewing the cup the flow automatically stops.
The mesh filter is fitted inside the recovery tank, directly fitted onto the end
of the vacuum motor cone. The purpose of the filter is to protect the vacuum
motor from foreign matter which might enter through the extraction cone
during dry extraction.
It is recommended to clean the filter daily.
To clean the filter, remove it and wash it under running water. Fit it back onto
the cone, taking care to fit it securely onto the cone3.
15.7. SQUEEGEE DRYING BLADE REPLACEMENT
15.8. CLEAN WATER FILTER CLEANING
15.9. EXTRACTION FILTER CLEANING
https://harrissupplyind.com - To Order Parts Call 608-268-8080
