PAS26R CROSSOVER AUTOMATIC SCRUBBER
14
12. MACHINE PREPARATION AND COMMISSIONING
Before leaving the machine unattended or performing any maintenance operation, ensure it is on a flat
surface, turn off the machine and remove the key.
1. Lift the entire brush plate and turn the start key counter-clockwise to “OFF” to turn off the machine.
2. Rotate the solution tank cover.
3. Paying attention to the level shown in the small gauge pipe located on the side of the tank under the
filling spout the solution tank may be filled to maximum filling capacity (20 gallons),
To avoid damaging the tank, the water temperature must not exceed 120°F.
Measure the amount of chemical in the solution tank after filling it with water. Before adding powder detergent into the
tank of the solution, dissolve the powder detergent completely in a separate container.
NOTE: Before operating the machine, perform preliminary inspection.
Before starting the machine, ensure all safety devices work correctly.
1. The operator must be on the drive seat and keep his left foot on the brake pedal. To avoid any unintentional
movement, the accelerator pedal must not be pressed.
NOTE: To move the machine in the desired direction, the operator must be seated in the driving seat because a safety
device that detects the seated operator is installed under the seat.
2. Turn the ignition key clockwise into the “ON” position.
3. Check the Set Travel direction, and select it on the Forward or Backward selector.
4. With the operator seated and key “ON”, the parking brake is automatically released. Now, slightly press the
accelerator pedal and move the vehicle into the filling area by turning the steering wheel.
FOR SAFETY
FOR SAFETY
12.1. MACHINE START UP
12.2. MACHINE FILLING
https://harrissupplyind.com - To Order Parts Call 608-268-8080
