Powermatic PM2244, Инструкция по эксплуатации и каталог запасных частей

Страница: 6 / 100

6
The specifications in this manual were current at time of publication, but because of our policy of continuous
improvement, Powermatic reserves the right to change specifications at any time and without prior notice, without
incurring obligations.
5.0 Setup and assembly
Figure 2
5.1 Shipping contents
See Figure 2.
1 Sander unit
1
Handwheel with handle – A
2 Extension tables – B
2
Infeed table brackets (L and R) – C
2 Outfeed table brackets (L and R) – D
2 Caster lock knobs – E
16 Socket hd. cap screws M8x20 - HP1
16 Lock washers M8 - HP2
16 Flat washers M8 - HP3
Read and understand all
assembly instructions before attempting
assembly. Sander must be disconnected from
power during assembly procedures. Failure to
comply may cause serious injury.
5.2 Tools required for assembly
Hex wrenches 4mm, 6mm
Open-end wrench 14mm
Straight edge (such as straight steel bar or carefully
jointed board)
5.3 Unpacking and cleanup
1. Inspect all contents for shipping damage.
Compare contents of shipping carton with the
contents list in this manual. Report any damage
or part shortages to your distributor.
Sander is heavy! Use an
assistant to help remove from pallet.