Installation and operating manual
Page 57 of 95
(PVI-3.8/4.6-I-OUTD Rev.: 1.5)
5.5.2
Error messages
After the connection has been established, if the inverter detects incorrect information
in the test cycle, the system will interrupt this cycle, indicating the error code. Refer to
the table in paragraph 5.4 for information on error codes.
To customize the display message, use the programming procedure described in
chapter 5.5.6.14 “Alarm Message”.
Until the error has been solved, the system will continue to show the following cycle
of screens:
Once the error has been rectified, the inverter resets all of the function in progress,
restarting the connection (chapter 5.5.1, Connection of the system to the grid)
5.5.3
First phase - Electric parameter check
GENERAL QUESTIONS RELATING TO THE USE OF DISPLAY KEYS:
During regular operation, the display will cycle through available data. The screens
change every 5 seconds or can be alternated manually by pressing the UP and DOWN
keys (see Fig. 20).
In any case, to return to the previous menu, press the ESC key (see Fig. 20).
Fig. 21
Activation of cyclical scrolling is indicated by the 2 arrows in the top left-hand corner
of the display (Fig. 21).
Scrolling can be blocked by pressing the ENTER key. A padlock symbol will appear
(Fig. 21).
ERROR
Code ……..
Type OUTD
Part No………
In range
Custom msg………
S/N ………..……..
Firmware……
In range
