Power One AURORA MICRO-0.25-I-OUTD-US-208/240, Руководство пользователя, Страница: 39 / 78

Page
38
of
76 MICRO-0.25/0.3-I-OUTD-US-208/240 BCG.00612_AB
Part
3 Mounting and Wiring
3.2.1 I
NSTALLING THE
AC-TRUNK END CAP
The unused ends of the AC-TRUNK cable must be terminated with the proper end.
The following is necessary for properly installing the cap:
1 Fit the ring nut and gasket around the cross section of the cable to terminate.
2 Strip 50 mm/1.97 inches of the external insulation and separate each conductor.
3 Insert the conductors into the recesses inside the cap to block them.
4 Insert the gasket into the cap with slight pressure.
5 Screw the ring nut to apply the correct pressure on the gasket (max.2.45Nm/1.81 ft-lbs).
6 Secure the section of the terminated cable to the frame structure with cable ties.
3.2.2 U
SE OF THE
AC-TRUNK UNLOCK TOOL
The AC-TRUNK UNLOCK TOOL must be used for the disconnection of the AC connector from the
MICRO inverter or for the removal of the AC-TRUNK PLUG CAP from the connectors on the AC-
TRUNK cable.
The tool is used to release the two retaining clips on the connectors installed on the AC-TRUNK
cables. The disconnection or cap removal can be performed in three simple steps:
•
Insert the AC-TRUNK UNLOCK TOOL in the
two holes on the connector or cap.
•
Press to release the retaining clips.
•
Remove the connector or cap.