Power One AURORA MICRO-0.25-I-OUTD-US-208/240, Руководство пользователя, Страница: 14 / 78

Page
13
of
76 MICRO-0.25/0.3-I-OUTD-US-208/240 BCG.00612_AB
Part
1 Introduction and Safety
1.2.1.3
Assembly Warnings
Prior to installation, inspect the unit to ensure absence of any transport or handling damage, which
could affect insulation integrity or safety clearances; failure to do so could result in safety hazards.
Assemble the inverter per the instructions in this manual. Use care when choosing installation
location and adhere to specified cooling requirements.
Unauthorized removal of necessary protections, improper use, incorrect installation and operation
may lead to serious safety and shock hazards and/or equipment damage.
1.2.1.4
Electrical Connection Warnings
This grid-tied inverter system operates only when properly connected to the AC -distribution
network. Before connecting the AURORA MICRO to the power distribution grid, contact the local
power distribution grid company to get appropriate approvals. This connection must be made only
by qualified technical personnel
CAUTION
:
Systems with inverters typically require additional control (e.g., switches,
disconnects) or protective devices (e.g., fusing circuit breakers) depending
upon the local safety regulations.
It is the responsibility of the installer to provide external disconnect
switches and Overcurrent Protection Devices (OCPD) as required by
National Electric Codes and other prevailing regulations.
WARNING
:
Power-One DOES NOT provide AC output overcurrent protection. To
reduce the risk of fire, connect only to a circuit provided with 20A
maximum branch circuit overcurrent protection in accordance with the
National Electric Code (ANSI/NFPA 70).
Make all electrical connections (e.g. conductor termination, fuses, PE
connection, etc.) in accordance with the electrical standards prescribed by
the applicable National Electric Code, ANSI/NFPA 70 wiring methods
and/or by other local regulations and codes.
CAUTION
:
The AC output (neutral) is not bonded to ground.
The input and output circuits are isolated from the enclosure and the
system grounding shall be installed per the requirements of the National
Electric Code, ANSI/NFPA 70, and is the responsibility of the installer.