Troubleshooting
ROBO-8714VG2A User’s Manual
5-4
Step 2: If currently using ATX mode, please remove 4 pins power cable, and then
put a jumper back on pin 3 (PS-ON) and pin 4 (GND) of backplane ATX P/S
control connector. (Figure 5-6)
Figure 5-6
Step 3: Please connect 12 V Power to CPU supplementary Power Connector (J1),
which shows on Figure 5-1.
Stand-alone Setting
The purpose of system stand-alone function is to identify the root cause by isolating
the board from other possible system devices such as PCI device, backplane, and so
on. Please refer the following steps to make system at stand-alone status.
Step 1: Please connect 4 pins power to J7 in order to make system stand-alone (See
Figure 5-7)
Figure 5-7
