Porsche 9Y0.971.675.BE, Руководство пользователя

Страница: 67 / 1111

65
1. Time of printing. Further information is available from your Porsche partner or your local electricity supplier.
DANGER
DANGER
DANGER
D
Wide contact surface between terminal plate and
wire
Requirements for cable installation
Unsuitable power cable
The use of unsuitable power cables or excessive
electrical currents can cause a short circuit, electric
shock, explosion, fire or burns.
e The cable must have a 50-amp fuse.
e
Only use copper cables with a minimum cross-
section of 8 AWG, or preferably 6 AWG.
Requirements for outdoor installation
Direct contact with rain
If the charging equipment is used outdoors, direct
contact with rain can cause a short circuit, electric
shock, explosion, fire or burns.
e Prevent the charging equipment from coming
into direct contact with rain.
e
Use a NEMA 3R rainproof enclosure.
Changing supply cables and vehicle ca-
bles
Electric shock
Risk of serious or fatal injury from electric shock.
e Before changing the supply cable, always unplug
the supply cable from the electrical socket and
disconnect the vehicle cable from the vehicle
charge port.
e
Only change cables in a dry environment.
e Use only cables approved by Porsche.
g Refer to chapter "Scope of supply" on page 54.
In some countries, e.g. in Norway, Italy, Portugal and
Spain
1
, the supply cable may only be changed by a
qualified electrician. Porsche recommends that you
use a certified Porsche service partner.
Fig. 36 Connections on the control unit
The supply cable
A
can be removed and inserted at
the top of the control unit.
The vehicle cable
B
is removed and inserted at the
bottom of the control unit
Disconnecting cables
Fig. 37 Disconnecting cables
b
Charging of the high-voltage battery has ended
and the vehicle plug has been removed from the
vehicle charge port.
b The plug has been disconnected from the elec-
trical socket.
1. Remove screw
C
(Fig. 37) using a suitable tool.
2. Lift lever
A
(Fig. 37).
3. Pull out plug
B
(Fig. 37) until you first feel resist-
ance.
4. Close lever
A
(Fig. 37).
5. Pull out plug
B
(Fig. 37) fully.