Transmitter Channel A/B select
The pool side alarm RF (radio frequency) signal can be transmitted
from the transmitter to the receiver inside the house by two different
channels (A or B). All units are preset at channel A in the factory.
However, if your alarm system interferes your neighborís alarm
system, you may have to change your alarm unit to channel B.
The pool side alarm unit has a built-in channel select switch. This is
located inside the battery compartment. Follows these instructions
to change the channel.
1. Open the battery door and remove the
battery. You can see an A/B slide switch
located at the cor ner of batter y
compartment.
2. Use a screw driver to push the switch
handle from A to B. Make sure to do the
same channel adjustment on ALL your
POOLEYE devices, including the receiver.
