Q. The receiver cannot receive RF alarm signal.
When the blue RESET button on the front is pressed, the
unit is disabled for 10 seconds. During this 10 seconds, it will
not receive any RF signal. This allows you enough time to go
to the poolside to turn off or reset the poolside alarm.
Check the channel A or B select. Make sure every unit is set
at the same channel.
Place the receiver closer to the transmitter and at a straight
line of sight. The RF signal sending out from the transmitter
is directional. Placing the receiver at another location may
give a better reception. Avoid any big metal object such as
refrigerator, oven or washing machine etc. between them.
The transmitter has an antenna inside the control head.
Rotating the control head may affect the RF signal sending
out, similar to your TV antenna. Make sure the wide side of
the underwater sensor remains parallel to the pool wall.
Q. Pool alarm sounds off when I use my pool cleaner
Your pool cleaner can create the same type of water
disturbance as that created by a child falling into water.
Therefore the pool alarm will be set off if you activate your
automatic pool cleaner while the alarm is ON.
Q. The receiver alarm siren cannot be turned OFF
Press the SYSTEM RESET switch located on the back of
the unit.
SmartPool, Inc.
687 Prospect Street
Lakewood, NJ 08701
