Remote receiver
Place the remote receiver inside your house but close to the pool side
alarm unit and at a straight line of sight. DO NOT place the unit
near large metal objects or large motors, such as a refrigerator, or
washing machine. This will adversely affect the RF reception
Plug in the A/C adapter and the green LED will stay ON, indicating it is
ready to receive signals.
Hit the RESET button located between the two
LEDs, to reset the receiver. Each reset will
disable the receiver for 10 seconds, allowing
you enough time to go to the pool side
alarm transmitter to reset it, or turn it off.
During this 10 second timeframe, the red
LED will flash every 1 second. If you do not
reset the receiver, it will reset automatically
in four minutes.
Remote Receiver Channel A/B select
The pool side alarm or other POOLEYE alarms RF (radio frequency)
signal can be transmitted from the transmitter to the receiver inside
the house by two different channels (A or B). All units are preset at
channel A in the factory. However, if your alarm system interferes
your neighborís alarm system, you may have to change them to
channel B.
The remote receiver has a built in channel select switch, located inside
the receiver box. Loosen the four screws and remove the battery
door. You can find a slide switch at the corner that mark ìAî and ìBî.
Push the switch handle from position ìAî to position ìBî. Make sure
you do the same channel adjust on all your POOLEYE devices,
including the pool side alarm transmitter. Check the RF link
periodically to ensure good RF transmission.
