Polyprint S.A.
Polyprint S.A
– Texjet plus operation manual English V1.9
- 38 -
Transporting the printer
Packaging the printer for transportation
Please make sure you have performed the following procedures before transporting the printer.
1.
Clean all the ink cartridges and place distilled water mixed with the inks cleaner.
2.
Perform 5 powerful cleanings until dampers and Printhead are clean too.
3.
Switch of the printer and remove the power gable and the data cable.
4.
Remove the cartridges and place them in a plastic bag.
5.
Empty the Maintenance Tank and put it back empty to the printer.
6.
Make a basic and weekly maintenance on the printer.
7.
Place the transport brake for the plate.
8.
Repack the printer in the box it was shipped in. If you are returning the printer for repair you do not
need to include the inks or any of the accessories including the USB cable, printer drivers or RIP
software. You should include the power cord.
9.
Try to keep the printer level while transporting it.
10.
Remember that when using any common carrier, the printer is there and your responsibility until it is
received in good condition at our facility. Make certain to insure the printer for the full value.
Carry the product by 2 or more persons
Don’t forget to empty the Maintenance tank (waste tank) of the printer, or you may damage the
printer.
Moving the printer to another position
Please make sure you have performed the following procedures before moving the printer.
1.
Switch of the printer and remove the power gable and the data cable.
2.
Empty the Maintenance Tank and put it back empty to the printer.
3.
Place the transport brake for the plate
Carry the product by 2 or more persons
Don’t lift the product from the side covers
Place this product on a flat, stable surface. The surface should be at least 64x59cm. Texjet stand
recommended
This product will not operate properly if it is tilted or at an angle
The printer must only be used indoor
Avoid places subject to rapid changes in temperature and humidity. Also keep this product away
from direct sunlight, strong light, or heat sources
Avoid places subject to shocks and vibrations
Keep this product away from dusty areas
If you use a stand, the stand must be at least 64x59cm and able to support 125Kg (275lb)
Operate the machine in an environment with a temperature range of 10-30 degrees Celsius
The humidity must be between 20-80% none condensing
Before moving the printer to other position, empty the maintenance tank from the remaining ink
Always put the printer into a place where the lighting is sufficient
Place this product near a wall outlet where the plug can be easily unplugged
