Polarstart PS-5565TW, Руководство по установке

Страница: 7 / 18

7
11 PIN-ACCESSORIES HARNESS
Wire Wire color
Function Description
8 BROWN LOCK (-)
Programmable 500 mA. ¾ sec – 4 sec – or DBL pulse negative
output.
9 GREEN UNLOCK (-)
Programmable 500 mA. ¾ sec – 4 sec – or DBL pulse negative
output.
10 BLUE TRUNK OR
AUX 3 (-)
500 mA negative output. This output can be used to control the
trunk release (1 sec. pulse) or can be set to operate as a Constant as
long as channel 3 is pressed. (For sun roof or window close)
11 WHITE /
YELLOW
STARTER KILL
(ARMED UTPUT)
(-)
This wire will provide a constant 500 mA. output when the system
is ARMED (Locked by remote). Can be connected to external
starter interrupt relay.
12 WHITE /
BLACK
NEGATIVE
DOOR INPUT (-)
Connect to the wire that will test ground with the door open.
NOTE: This wire should monitor all the doors.
13 ORANGE/B
LACK
POSITIVE DOOR
INPUT (+)
Connect to the car circuit, usually the dome light circuit, which
gives +12V when a door is opened .
14 YELLOW GLOW-PLUG
INPUT (+)
This positive input will monitor the glow plug light in DIESEL
mode, and will wait until the glow plug light goes out to CRANK
the vehicle. Connect to the positive when ON side of the glow plug
light in the vehicle.
15 WHITE /
GREEN
DISARM (-) Max 500 mA. 1 sec ground pulse when the doors are unlocked by
remote. Connect to vehicle’s OEM DISARM wire.
NOTE: System
will also give Disarm pulse before remote start on this wire.
16 RED SIREN OUTPUT
(+)
+12V siren output. Connect to the positive side of the siren
17 BLUE
/BLACK
PARKING
BRAKE WIRES
(-)
This input (required for all manual transmission starters) must be
negative when the parking brake is engaged.
18 WHITE/
BROWN
ARM (-)
MAX 500 mA. ground signal when the doors are locked by remote.
This wire will go to ground ¼ sec before the LOCK pulse, and go
off 1/8 sec after Lock. Must be connected to the OEM Arm wire.
NOTE: System will also give RE-ARM pulse after remote start
shutdown on this wire.
19 GREEN
(Separate
Wire)
AUX 2 5
th
relay output for 2
nd
IGNITION, accessories or CRANK.
See jumper setting for proper slot location.