12
PROGRAMMING OPTIONS
The PS-5565TW System is equipped with 2 custom programming menus that allow the user to custom fit
the system’s outputs according to the installation requirements.
These options are designed to help make interfacing with all vehicles possible.
To get into custom programming mode you must do the following:
*
Ensure that the IGNITION and the VALET switch are turned OFF .
1. Hold HOOD switch down for 4 sec.
2. Release HOOD switch. (PARKING LIGHTS will come ON)
3. Immediately push and release HOOD switch once again. (PARKING LIGHTS will stay ON
for 20 sec.)
4. Press and hold brakes, and press LOCK button or START button on remote transmitter.
(
LOCK button for mode one, START button for mode two)
PARKING LIGHTS will flash
once for mode 1, or twice for mode 2.
5. Release the brakes.
*Once you’ve entered one of the two programming menus you can release the brake pedal.
NOTE:
The unit will stay in programming mode until the HOOD switch is pressed or the VALET switch
has been turned OFF. (
So take your time to make the proper selection)
The menu will automatically start at function one. Once you choose from one of the three Options, you
will automatically advance to the next function.
§
To select one of the three options press the appropriate transmitter buttons. (See below)
1. Button 1 (LOCK) = Option 1
2. Button 2 (START) = Option 2
3. Button 3 (TRUNK) = Option 3
* See Transmitter Function for button layout.
Once an option has been selected, the PARKING LIGHTS will flash 1, 2 or 3 times. (
Depending on option
selected)
Ø
MODE 1
*INDICATES DEFAULT SETTING
FUNCTION 1 – Ignition Controlled door locks / Secure Lock
OPTION 1*
Ignition Lock ENABLED
OPTION 2
Ignition Lock DISABLED
OPTION 3
Ignition Lock DISABLED & Secure LOCK ENABLED
FUNCTION 2 – Not Used
Press LOCK or START button to go to FUNCTION 3.
FUNCTION 3 – CHIRPS Enable/Disable
OPTION 1*
Chirp ENABLED
OPTION 2
Chirp DISABLED
FUNCTION 4 – Passive/Active Arming
OPTION 1*
PASSIVE Arming
OPTION 2
ACTIVE Arming
